Completed Projects
Design, Development & TOT of DSP based controller (hardware and firmware) for FOC of 2 x PMSM Motors for EV
- This project consist of design & development of the following,
- DSP Based Control Board Suitable for Field Oriented Control of 2 x Permanent Magnet Synchronous Motors with regenerative braking and CAN Bus communication as per SAE J1939 protocol.
- Interface Board Suitable to cover IOs as per customer specification.
https://athashreeanuvidyut.com/wp-content/uploads/2023/04/New-video8.mp4
Supply of DC-DC Converters for Water Electrodeionization (EDI) process
Input: 530-550VDC (From SCR Based DC Source)
Auxiliary Supply Input: 230V, 50Hz, 1 Phase AC
Mode of operation: Constant Current Mode
Rating: 1225W max. (For Upper Stage) 0875W max. (For Lower Stage)
Output Current:
1.5A to 3.5ADC ± 0.1A (Settable For Upper Stage)
1.5A to 2.5ADC ± 0.1A (Settable For Lower Stage)
Output Voltage Range: 100V to 350VDC (Operating value will depend on load)
Previous
Next
https://athashreeanuvidyut.com/wp-content/uploads/2023/04/Video12.mp4
Supply of Thyristor Based Static Switch (100A) Assembly Units
Previous
Next
Supply of duly assembled, programmed and tested Digital Control Board for v/f control of 3 Phase Induction Motor for solar water pump application
Design, Development & TOT of Dual-channel IGBT/MOSFET Driver
Repair & supply of power and control cable assemblies for Wind Turbine Generators
